CML Lab: IOSV added device has no console

[CiscoMedMed]

When running CML - I am tryin to add an iosv router. It appears to succeed but I can not

get a console. Or when I can it's just a blank screen. Any ideas? Thank you.

[Martin L]

CML Sometimes does that; stop and start device again; make sure image Dvd is attached and on.

Make sure device is fully booted; and make sure you have enough resources to run topo.  I see you have Nexus switches, if those are 64-bit, they take lots of resources!  CPU or RAM that could be your issue.  what are your PC specs?

also see https://developer.cisco.com/docs/modeling-labs/#!faq/faq---cisco-modeling-labs-v2x

Regards, ML
**Please Rate All Helpful Responses **