Console not returning any syntax

[chriswill]

HI,

   I have just installed CML personnel on my Mac Book using VMware Fusion Pro. If I start a single node type eg IOSV router eventually it starts and I can console to the device. If I start two IOSV nodes once booted I get no console output. System health is all good whilst these devices are starting up. 

What have I missed here?

Any help appreciated.

[chriswill · Accepted solution]

Found a post here around the hardware compatibility being too low a version for that VM in Fusion Pro.

Set it up to 18 and it works fine now