Help setting up a vWLC node in CML 2.0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-25-2020 02:31 PM
So, I finally made some time to install Cml 2.0, I was hoping to set up a simulation with a virtual Wireless LAN Controller but I've had no luck figuring out how to add device so that I can use it in a lab. I've wasted most of the day trawling the Interwebs looking for solutions etc but to no avail.
Gotta say, given the cost and the lack of documentation and support that so far I'm not particularly impressed.
- Labels:
-
Cisco Modeling Labs
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-22-2020 02:27 AM
I'm not sure this would be possible to add a vWLC into CML as it's a VM.
I'd recommend you setup a separate virtual machine with the vWLC and connect it to your CML lab via an external connection.
