cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
669
Views
0
Helpful
5
Replies
Highlighted

Multiple FLAT interfaces (dot1q) on CML?

Hi I would like to connect CML to a traffic generator simulating PEs through one physical interface on the Hypervisor using Vlan. But during the installation of CML (settings.ini) I don't see any option in order to setup multiple FLAT networks.

Any idea if it is supported?

 

Many thanks!

 

Youssef

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Beginner

Hello Youssef,Yes, you are

Hello Youssef,

Yes, you are correct..

 

Thanks & Regards,

Vidyasagar.

View solution in original post

5 REPLIES 5
Highlighted
Cisco Employee

Youssef, Thanks for the

Youssef,

 

Thanks for the question!  We'll have someone check into that and someone will post an answer as soon as we have something to share.

Thanks,

DavidM

Highlighted
Beginner

still be nice to have

still be nice to have multiple flats without vlans. 

Highlighted
Enthusiast

Hi You can specify multiple

Hi You can specify multiple interfaces and VLANs are part of the setup -

See page 21 – Step 12 – of the Install Guide (http://www.cisco.com/c/en/us/td/docs/cloud_services/cisco_modeling_labs/v100/installation/guide/administrator/b_cml_install_sys_admin.html)

 

Highlighted

Hi, so I can repeat Step 12

Hi, so I can repeat Step 12 and finally have more than one FLAT network, it will be taken in account in the settings.ini file of CML?

Am I correct?

 

Thanks!

 

Youssef

Highlighted
Beginner

Hello Youssef,Yes, you are

Hello Youssef,

Yes, you are correct..

 

Thanks & Regards,

Vidyasagar.

View solution in original post

CreatePlease to create content
Content for Community-Ad
Cisco Community July 2020 Spotlight Award Winners