09-08-2014 01:38 AM
Hi I would like to connect CML to a traffic generator simulating PEs through one physical interface on the Hypervisor using Vlan. But during the installation of CML (settings.ini) I don't see any option in order to setup multiple FLAT networks.
Any idea if it is supported?
Many thanks!
Youssef
Solved! Go to Solution.
09-09-2014 07:14 AM
09-08-2014 06:31 AM
Youssef,
Thanks for the question! We'll have someone check into that and someone will post an answer as soon as we have something to share.
Thanks,
DavidM
11-19-2014 10:35 PM
still be nice to have multiple flats without vlans.
09-08-2014 02:14 PM
Hi You can specify multiple interfaces and VLANs are part of the setup -
See page 21 – Step 12 – of the Install Guide (http://www.cisco.com/c/en/us/td/docs/cloud_services/cisco_modeling_labs/v100/installation/guide/administrator/b_cml_install_sys_admin.html)
09-08-2014 02:24 PM
Hi, so I can repeat Step 12 and finally have more than one FLAT network, it will be taken in account in the settings.ini file of CML?
Am I correct?
Thanks!
Youssef
09-09-2014 07:14 AM
Hello Youssef,
Yes, you are correct..
Thanks & Regards,
Vidyasagar.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: