06-23-2022 02:34 AM
bonjour, j’ai actuellement un problème avec mon routeur Cisco ISR 1100 Séries .l’ors du démarrage du routeur, automatiquement il se retrouve en mode ROMMON cela est très problématique car après avoir chercher dans la flash j ai pu constater que l OS avais disparue . nous avons essayer de mettre un os sur une clef et de redémarrer le routeur mais rien n’a marcher. avais vous une idée de comment résoudre mon problème?
Solved! Go to Solution.
06-24-2022 12:43 AM
06-24-2022 04:05 AM
Look at the error message: Invalid SPACE in the boot command.
The correct command does not have a space:
boot usb0:asr1001x-universalk9.16.09.05.SPA.bin
Do not put a "space" after the "usb0:" and the filename.
06-23-2022 02:38 AM
If the router is in ROMMON, post the complete output to the following commands:
06-23-2022 02:53 AM
c est cela que vous vouliez?
06-23-2022 02:55 AM
06-23-2022 04:15 AM
Merci.
Someone has erased the firmware file(s) from the router.
Download the file into a USB thumb drive and use the command: boot usbflash0:IOS_filename.bin
06-23-2022 05:40 AM
sa ne marche toujours pas je ne comprend pas
06-23-2022 04:32 PM - edited 06-24-2022 12:44 AM
The syntax is wrong.
boot usb0:FILENAME.bin
IMPORTANT:
After the router boots the firmware do the following additional steps to put the firmware packages back into the router:
copy usb0:FILENAME.bin bootflash:
request plat soft package expand file bootflash:FILENAME.bin over verbose
conf t
boot system flash bootflash:packages.conf
end
wr
After saving the config, reboot the router.
06-24-2022 12:18 AM
sa ne marche toujours pas
06-24-2022 12:43 AM
Ok, so try:
boot usb0:filename.bin
06-24-2022 02:36 AM
merci beaucoup cela a fonctionner!
06-24-2022 03:15 AM
Hey, don't forget to put the back into the router!
06-23-2022 07:26 AM
ISR 1000 has USB option, so get image on USB and boot from USB (is that works ?)
06-24-2022 12:01 AM
si vous voulais dire que sur le routeur lors du démarrage il boot sur la clef je les fais et cela n'a malheureusement pas fonctionner
06-24-2022 04:05 AM
Look at the error message: Invalid SPACE in the boot command.
The correct command does not have a space:
boot usb0:asr1001x-universalk9.16.09.05.SPA.bin
Do not put a "space" after the "usb0:" and the filename.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide