Aironet 2600-GUI

[Alex-1985]

Hello , 

I have an issue with GUI Interface, like a lot of people before me, when I want to change settings with network interface it return "404-not found". 

I tried with two firmwares, and both have the same issue. 

My procedure is to format flash:, than with command tar -xtract tftp://(IP)/Firmaware) flash:  , load and extract flash automatically. I think that http files are also there as it should be, or I am mistaken?

I activate "ip http secure" with CLI.

I found that certification may be problem, I made like it is written in manual but nothing seems to work. Am I using correct manual? 

Is anyone that could tell me what i need for working GUI. 

Manals for ser http and pki rsa-ca. I need to set all this?

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/https/configuration/12-2sy/https-12-2sy-book/nm-http-web.html

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_conn_pki/configuration/15-mt/sec-pki-15-mt-book/sec-deploy-rsa-pki.html

Access point Aironet 2600e stand alone for home. 

[balaji.bandi]

have you tried different browser IE/FF ?

[Alex-1985]

Hello, 

Until now no. I tried just with Edge and Chrome. I will try to download FF 17 and see.

[Alex-1985]

Hi, 

Nothing helps. Firmware load, extract, configure BVI 1, open GUI with Chrome, Edge, Firefox 17. Everywhere I get same error. 

command : "ip http server" I also create new certificates. Nothing works. All ideas are welcome, because I have run out of them. 

Thank you in advance.  

[Harikrishnan C]

Its seems like bug,  This product is no longer supported by Cisco

https://www.youtube.com/watch?v=JkUfTXuwj2U&t=332s

[Alex-1985]

I load two different firmwares. Both with same bug. Unbelievable. I have one aironet configured with CLI and works like a charm, but I would really like that GUI would also work.  Thank's for reply.

[Alex-1985]

Another question: anyone knows <local interface ip>, is it correct that I put in static IP of aironet, or I should put in routers IP?

Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)# crypto pki trustpoint TEST
Router(ca-trustpoint)# enrollment url http://<local interface ip>:80 # Replace <local interface ip> with the IP address of an interface on the router
Router(ca-trustpoint)# subject-name CN=TEST
Router(ca-trustpoint)# revocation-check none
Router(ca-trustpoint)# rsakeypair TEST
Router(ca-trustpoint)# exit

[balaji.bandi]

yes if that is enrol locally.

[Alex-1985 · Accepted solution]

yes it is locally. But now it is not important anymore. I found version ".JF10.tar" that it works http as soon as firmware is installed. 

When I had working HTTP, I tried to upgrade to ".JF12.tar" from web interface. After reboot error "not found 404" returned. 

So my problem is saved with .JF10 firmware.

Thank you all for replies and have a great time , till next time