12-07-2022 02:19 AM
Hello ,
I have an issue with GUI Interface, like a lot of people before me, when I want to change settings with network interface it return "404-not found".
I tried with two firmwares, and both have the same issue.
My procedure is to format flash:, than with command tar -xtract tftp://(IP)/Firmaware) flash: , load and extract flash automatically. I think that http files are also there as it should be, or I am mistaken?
I activate "ip http secure" with CLI.
I found that certification may be problem, I made like it is written in manual but nothing seems to work. Am I using correct manual?
Is anyone that could tell me what i need for working GUI.
Manals for ser http and pki rsa-ca. I need to set all this?
Access point Aironet 2600e stand alone for home.
Solved! Go to Solution.
12-08-2022 03:34 AM
yes it is locally. But now it is not important anymore. I found version ".JF10.tar" that it works http as soon as firmware is installed.
When I had working HTTP, I tried to upgrade to ".JF12.tar" from web interface. After reboot error "not found 404" returned.
So my problem is saved with .JF10 firmware.
Thank you all for replies and have a great time , till next time
12-07-2022 03:12 AM
have you tried different browser IE/FF ?
12-07-2022 05:49 AM
Hello,
Until now no. I tried just with Edge and Chrome. I will try to download FF 17 and see.
12-07-2022 10:34 PM
Hi,
Nothing helps. Firmware load, extract, configure BVI 1, open GUI with Chrome, Edge, Firefox 17. Everywhere I get same error.
command : "ip http server" I also create new certificates. Nothing works. All ideas are welcome, because I have run out of them.
Thank you in advance.
12-07-2022 10:40 PM
Its seems like bug, This product is no longer supported by Cisco
12-07-2022 10:56 PM
I load two different firmwares. Both with same bug. Unbelievable. I have one aironet configured with CLI and works like a charm, but I would really like that GUI would also work. Thank's for reply.
12-07-2022 11:14 PM
Another question: anyone knows <local interface ip>, is it correct that I put in static IP of aironet, or I should put in routers IP?
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# crypto pki trustpoint TEST
Router(ca-trustpoint)# enrollment url http://<local interface ip>:80 # Replace <local interface ip> with the IP address of an interface on the router
Router(ca-trustpoint)# subject-name CN=TEST
Router(ca-trustpoint)# revocation-check none
Router(ca-trustpoint)# rsakeypair TEST
Router(ca-trustpoint)# exit
12-08-2022 03:24 AM
yes if that is enrol locally.
12-08-2022 03:34 AM
yes it is locally. But now it is not important anymore. I found version ".JF10.tar" that it works http as soon as firmware is installed.
When I had working HTTP, I tried to upgrade to ".JF12.tar" from web interface. After reboot error "not found 404" returned.
So my problem is saved with .JF10 firmware.
Thank you all for replies and have a great time , till next time
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide