08-22-2022 08:48 AM
I recently purchased a FL-VPERF-8P-200 license to increase the throughput of my IPSec tunnel to 250 Mbps. I received the PAK and added it to my smart account. From here I am stumped. I cant figure out how to enable this feature on my C1111-8P. When I am in the device, if I do RTR(config)# lic feature ? the only feature available is hseck9, but I did not buy an hsec license, only a vperf.
Can anyone assist in letting me know how to enable this feature after the license has been converted over to my smart account?
Solved! Go to Solution.
08-25-2022 12:09 PM
Although I had no luck here, I was able to find the solution.
To enable the IPsec Performance License on a Cisco ISR 1100 perform the following:
Upon reload, call-home will verify license and enable 250Mpbs crypto throughput.
08-22-2022 10:56 AM
Can you post :
#show license sum
#show version
Anything above 16.9.X is smart License only.
08-22-2022 12:36 PM - edited 08-22-2022 12:37 PM
RTR#show lic sum
Smart Licensing is ENABLED
Registration:
Status: REGISTERED
Smart Account: *********
Virtual Account: *********
Export-Controlled Functionality: ALLOWED
Last Renewal Attempt: None
Next Renewal Attempt: Oct 22 12:02:46 2022 EST
License Authorization:
Status: AUTHORIZED
Last Communication Attempt: SUCCEEDED
Next Communication Attempt: Sep 08 10:21:45 2022 EST
License Usage:
License Entitlement tag Count Status
-----------------------------------------------------------------------------
Cisco 1100 Series wi... (ISR_1100_8P_Security) 1 AUTHORIZED
The IOS is: Cisco IOS XE Software, Version 16.12.04
08-25-2022 12:09 PM
Although I had no luck here, I was able to find the solution.
To enable the IPsec Performance License on a Cisco ISR 1100 perform the following:
Upon reload, call-home will verify license and enable 250Mpbs crypto throughput.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide