Hello
I run Cisco IOS XR Software, Version 6.0.1
example
PC5 (e0/0.10) ---- (g0/0/0/2.10) R1 (g0/0/0/4.10) ---- PC6 (e0/2.10)
But PC5 cannot ping PC6, what is the problem?
PC5
interface Ethernet0/0.10
encapsulation dot1Q 10
ip address 172.16.10.5 255.255.255.0
PC6
interface Ethernet0/2.10
encapsulation dot1Q 10
ip address 172.16.10.6 255.255.255.0
R1
RP/0/0/CPU0:R1#sh l2v bri bd 10
Legend: pp = Partially Programmed.
Bridge group: 10, bridge-domain: 10, id: 0, state: up, ShgId: 0, MSTi: 0
Aging: 300 s, MAC limit: 4000, Action: none, Notification: syslog
Filter MAC addresses: 0
ACs: 2 (2 up), VFIs: 0, PWs: 0 (0 up), PBBs: 0 (0 up)
List of ACs:
Gi0/0/0/2.10, state: up, Static MAC addresses: 0
Gi0/0/0/4.10, state: up, Static MAC addresses: 0
List of Access PWs:
List of VFIs:
RP/0/0/CPU0:R1#sh run int g0/0/0/2.10
interface GigabitEthernet0/0/0/2.10 l2transport
encapsulation dot1q 10
!
RP/0/0/CPU0:R1#sh run int g0/0/0/4.10
interface GigabitEthernet0/0/0/4.10 l2transport
encapsulation dot1q 10
!
RP/0/0/CPU0:R1#sh run l2vpn
l2vpn
bridge group 10
bridge-domain 10
interface GigabitEthernet0/0/0/2.10
!
interface GigabitEthernet0/0/0/4.10
!
Hope someone can help
Vincent
