Reimage 1140 from ASA to FTD

[mariusz2306]

Hi,

I am trying to reimage NGFW 1k series from ASA to FTD.
Managed to download software to flash, but when trying to setup boot I am getting the following error:

ciscoasa(config)# boot system flash:/cisco-ftd-fp1k.7.2.5-208.SPA
INFO: Converting flash:/cisco-ftd-fp1k.7.2.5-208.SPA to disk0:/cisco-ftd-fp1k.7.2.5-208.SPA

The system is currently installed with security software package 9.16.2.3, which has:
- The platform version: 2.10.1.172
- The CSP (asa) version: 9.16.2.3
Preparing new image for install...
!Image download failure -
Error status: Download failure - Internal error (10)
Error message: End point timed out. Check for IP, port, password, disk space or network access related issues.#
ERROR: Unable to set this url

Not sure why I am getting download error here since the file is already on flash. Any idea? 

Regards
Mariusz

[balaji.bandi]

check the space and copy the image to Disk0 and try 

follow below steps :

https://www.cisco.com/c/en/us/td/docs/security/firepower/quick_start/reimage/asa-ftd-reimage.html#id_57089

[mariusz2306]

Thanks for quick reply @balaji.bandi 

Image is on the disk0 already. When I am trying "boot system disk0:/cisco-ftd-fp1k.7.2.5-208.SPA" result is exactly the same

Free space is not an issue: 16106127360 bytes total (14761467904 bytes free).

I am following the article that you've posted.

[mariusz2306 · Accepted solution]

Problem has been solved by formating flash (from "firepower-failed mode") and copying the image once again from TFTP, from rommon mode.

[ajmn]

For more information about reimaging ASA to FTD using a flash-drive to copy the image, see here: https://youtu.be/HYKaJyJAy3E