10-18-2018 12:06 PM
All,
Saw a strange issue with a port channel configuration on two stacked (SVL) 3850's.
I suspect someone initially configured the port channel incorrectly, and now I cannot use that same number for a port channel group even if I delete it. I have rebooted the switch and even tried a write erase reload but it fails once I attempt to configure the port channel interface itself (I initially create it by putting two other interfaces into the channel group, then configure that po interface itself) and I get "Standby doesn't support this command". If I use any other number for a new channel group it works
10-18-2018 02:31 PM
10-18-2018 02:36 PM
I have seen this issue in both Denali 16.3.6 and 16.3.7, I thought upgrading it might fix it but it did not
10-18-2018 08:57 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide