Cisco Software Discussions

Every switch running IOS Version 12.2 (that I've checked so far) seems to remove blank lines when included within a banner. Version 15.0 seems to be fine. Example MOTD banner:*** Warning! *** On IOS Version 12.2 this currently shows:***Warning!*** an...

I've just accepted an offer from Cisco as a Software Engineer in the data department. From the reviews I've seen through glassdoor, it seems to be a comfortable place to work with good employee satisfaction. However, I'm a little worried after hearin...

Hi, This is only affecting one user so I am a bit annoyed. We have a UCCE 10.5 Supervisor set up in Finesse for live monitoring. But when she does try and live monitor an agent, there is no audio and then it goes off the hook after 10 seconds. I have...

Can we use the PCCE sandbox lab to develop and test a  BIB recording solution?

I have ISR 4321 and not be able to boot from flash and not be able to enter rommonI had received this message: PASSWORD RECOVERY IS DISABLED.Do you want to reset the router to the factory defaultconfiguration and proceed [y/n] ?yRouter clearing confi...

Hi everyone,I have problems with my ISRs 4221. Version is 16.7.1. After I generate rsa key and left router couple of days without power, when i enter show ip ssh, it says SSH disabled. Then I have to create a new rsa key. Did anyone have similar prob...

Is there a sandbox that can be used to test BIB call recording?  If yes, which one?  Are there any constriants? 

Please, I need help, after upgraded the device to version "isr4300--ucmk9.16.9.3.SPA.bin" the device request user name and password " didn't add users and password before" entered "user = admin, pass =admin" it's work but when access to config mode a...

I use Cisco AnyConnect Secure Mobility Client version 4.7 to connect to several different clients, but the drop down list only shows two connections.  I have to type in the connections for my other clients.  Is there a way to configure the AnyConnect...

When an agent transfers a call, how do I find the phone number that the agent transferred the call to?

Hello all, recently we got a Cisco Prime 3.6 installed to manage our networkdevices. Almost everything works greatexcept one thing.  Prime always returns with error "Failed to update the boot configuration in the device. Details: -Invalid Index".when...

I've downloaded the 2.1.1.2-Deploying Devices.pkt file from the Introduction to Packet Tracer v1.1 course, but it says it's not compatible with my version of Packet Tracer, v7.1.1. See attached screenshot. Any advice?

Anyone know of a work around or fix to create more than 8 GRE tunnels on a nexus 9k switch?  I haven't been able to find anything, and apparently 8 tunnels are the limit. Thanks.

HelloI have a quick question regarding IOS-XE on ASR900 routers. Are HSRP version 2 and subinterfaces not supported on the following platform?Cisco IOS XE Software, Version 16.09.03Cisco IOS Software [Fuji], ASR900 Software (PPC_LINUX_IOSD-UNIVERSALK...