Dear CommunityWe made a purchase recently of Meraki switches 4 qty for our client MS120-24-HW and licenses LIC-MS120-24P-3YR unfortunately, the Licenses part number were wrong as they cannot support the Hardwarethe correct part number should be LIC-M...
Hi all,Anyone else missing the weekly scheduled reports at the moment?Tried to sent them manually as well, but still no one receives them (different mail-domains).RegardsMarc
Is there any way to setup a couple second delay for this? Due to ISP's (Comcast) mostly, we get a bunch of false up/down alerts.Would be nice where it waits say 5 to 10 seconds before alerting the connection is down on our users VPN boxes.There is no...
Meraki is aware of the issue with adding, removing, and moving devices between networks. It is being worked on with the highest priority, more updates will be provided here as they become available. Apologies for the inconvenience. Regards, Meraki Te...
Is is possible to modify the syslog server setting for all switch networks rather than going through each individual network-wide >> general >> logging field?
My company has recently set up over 150 units of Z3C's across the country, and in some destinations we get these messages 'Disabled gateway bad connectivity'. Now in the example above, it's a bit weird since the signal strength is good(3 out of 5 lin...
Probably a stupid question, but other than a mention of this in the help documentation, i'm trying to figure out what this column is for. On all my devices on my switches, the column is empty if I make it visible. I would assume, by the name of the c...
I would love to use the Meraki full stack in my environment but the network is subject to LEIN audits every three years. Devices that pass criminal justice information are required to hold a valid FIPS 140-2 certificate. I have heard from many source...
My MSP recently had a client that purchased another company that is using a Meraki MX84 controller and their prior IT crew is being less than helpful getting us the information needed to log in to take ownership of it. I've tried calling support, but...
What is the meraki SLA for hardware replacement and warranty ? I thaught it was Next Business Day ?I had hardware fail and have been told they don't have any parts in Australia ?How can this be the case ?? How can cisco not have a good spare parts in...
HelloI am trying to find out what are the requirements for a UPS to support an MX 68 and a MS 210-48LP switch. I know you cannot give me a brand name (but if you can, thanks), but I am looking buy some thing from an appliance store.Stephen Keating
I have a full Meraki stack in a higher-ed environment, (2) MX 450 security appliance, (100+) MS 250 switches, and (500+) MR 33 42 and 84 wireless access points. Over the past few days, i have been complaints from users about latency and slow Internet...
This week question is not a usual pick 1 or pick 2 but rather a 'select all that apply', I can't hide my expectations for spoiler free comments but as always you can just post what you think is the correct answer. See you in a week with the correct a...
Anyone else seeing weird issues with the Dashboard today? I was able to access it just fine earlier today, but then access to the it just went belly-up. Not long after that, I began receiving all of these notifications that devices are going down at ...
Hi, I have an issue that I’d like some help with...I got a couple of Meraki access points that I’ve recently plugged in, and for some reason they just aren’t coming online. They show as offline in the Dashboard, and the only indicator I see on the AP...
