Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Maybe I'm missing something obvious here, but the phones we have connected to our UC320 both show a date of Jan 1. Where do we set the date and time? I didn't see anything in the configuration.
We have an ASA5505 with the Sec+ license. I'm comfortable setting up failover using tracked routes, and allowing simple inbound traffic to the current mapped interface IP. This requires that all internal destination IPs be PATed to the current inte...
The VPN client successfully connects to the PIX, but it doesn't appear that any traffic is passing through the tunnel. There is a site-to-site tunnel up that is working fine, it's just the RA stuff that doesn't. This had been working at one point, ...
I'm in the process of setting up a 3560G alongside an ASA 5505. What I'd like to do is have all traffic from vlan 10 to the internet be routed to 192.168.16.2 (the 'blue' inside interface), and all traffic from vlan 20 to the internet be routed to 19...
Just an FYI to others... I hit this snag too. The org had no networks, no devices, no licenses, and no other admins but me. However I still got this error.In my case, having SAML *enabled*, even though there were no roles assigned, was the problem...
Could we fall back to PAT in that case?global (outside2) 1 interfacestatic (inside,outside2) tcp interface www 192.168.1.10 www netmask 255.255.255.255static (inside,outside2) tcp interface smtp 192.168.1.11 smtp netmask 255.255.255.255
