ARE YOU THE HOST? 3rd PARTY API CONTROL

[ryan@portcitysound.net]

We are controlling a Room Kit Plus with with a 3rd Party controller and cannot for the life of us figure out what to send the codec to get past this.  We tried dtmf tones and been through the integration guide thoroughly.  Does anyone have any suggestions?  This is driving us crazy!!  

Thanks in advance!

-RDW

[luke.tallon]

I just found the answer to this question in the Crestron Labs forum under Cisco room devices driver 3.2.4 beta release. Then I realised I was looking at the API for SX80 which hasn't been update since 2017. 
I was then able to find the information in "Cisco Collaboration Endpoint Software API Reference Guide CE9.10" - 

xCommand Conference Call AuthenticationResponse.

Applies to: All products
Requires user role: ADMIN, USER
This command is only available for Cisco Webex registered devices. The command gives a
response to an authentication request based on the Conference Call[n] AuthenticationRequest
status.
USAGE:
xCommand Conference Call AuthenticationResponse [CallId: CallId]
ParticipantRole: ParticipantRole [Pin: Pin]
where
CallId:
Integer (1..65534)
Unique identifier of the call. During a call you can run the xStatus Call command to see the
CallId.
Default value: 0
ParticipantRole:
Host/Panelist/Guest
Host: Join as host.
Panelist: Join as panelist.
Guest: Join as guest.
Pin:
String(0, 32)
PIN code. Must be provided if joining as host, panelist or as guest when the Conference
Call[n] AuthenticationRequest status indicates that a PIN code must provided.
Default value: ""