cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

C60 Switching between far video source inputs

13
Views
0
Helpful
0
Comments
This document was generated from CDN thread

Created by: Alan Morales on 28-06-2010 07:31:34 PM
Hi,
I´m developing software applications for codec C60 with software TC2.1.1.200802

I´m wondering if it is possible to select an specific video output during a videconference.
I can switch far video sources, 0 to 15, but specifically a want to switch between the HDMI input and the DVI-I input from video source 2.

I am using:

xCommand FarEndControl Source Select CallId:X SourceId:7

This command only selects the video source but not the input I want, in this case between HDMI and DVI

For this command I know that SourceId 7 is the video source # 2, but there is no way to select the different inputs


is there any way I can do something like:

xConfiguration Video Input Source 2 Connector: HDMI,  

but in the FAR end???
This widget could not be displayed.