This document was generated from CDN thread
Created by: Alan Morales on 28-06-2010 07:31:34 PM
Hi,
I´m developing software applications for codec C60 with software TC2.1.1.200802
I´m wondering if it is possible to select an specific video output during a videconference.
I can switch far video sources, 0 to 15, but specifically a want to switch between the HDMI input and the DVI-I input from video source 2.
I am using:
xCommand FarEndControl Source Select CallId:X SourceId:7
This command only selects the video source but not the input I want, in this case between HDMI and DVI
For this command I know that SourceId 7 is the video source # 2, but there is no way to select the different inputs
is there any way I can do something like:
xConfiguration Video Input Source 2 Connector: HDMI,
but in the FAR end???