This document was generated from CDN thread Created by: stephane wolf on 31-08-2009 01:35:59 PM hellowould you have the API for the matrix switcher included in the C 90 (Input 1,2,3,4 in Output 1,2,3,4) ?my second question is that the cam connected to the main unit can't be control by the API codes, and when you use the remote in front of the camera, it only controls the camera (up dn left right and zoom) could you help methank youSubject: RE: API for C90 Replied by: David Bruun-Lie on 31-08-2009 01:57:09 PMstephane wolf:
hello
would you have the API for the matrix switcher included in the C 90 (Input 1,2,3,4 in Output 1,2,3,4) ?
Hi Stephane,not quite sure I understand the question, but the API for the matrix switcher has been in the C90 since release.Input switcher:1 xConfiguration Video Input Source 1 Connector: <HDMI/HDSDI/YPbPr>
2 xConfiguration Video Input Source 2 Connector: <HDMI/HDSDI/YPbPr>
3 xConfiguration Video Input Source 3 Connector: <HDMI/HDSDI/DVI>
4 xConfiguration Video Input Source 4 Connector: <HDMI/HDSDI>
5 xConfiguration Video Input Source 5 Connector: <DVI/Composite/YC>
Output switcher: look at commands under "xCommand Video Layout" in the system integrator guide (link to the guide is available under Products - C90)stephane wolf:
my second question is that the cam connected to the main unit can't be control by the API codes, and when you use the remote in front of the camera, it only controls the camera (up dn left right and zoom) could you help me
thank you
Are you using the "xCommand Camera Ramp" command and using the correct CameraId?You find the camera id by issuing "xstatus Camera". I don't think I understand the problem regarding using the remote control. You say it moves the camera - is that not what you want?Regards,David
