This document was generated from CDN thread Created by: Jeff Nicoll on 23-11-2009 09:55:39 PM Hi David,hope all is well with you.I was with one of my integrators last week and they have been installing several C60's with Crestron. They are using the code from this site and mentioned that the camera movement using the API is not as tight as the increments when using the remote.Is this code relate and if so, any suggestion?Thanks,jeffSubject: RE: Camera movement Replied by: David Bruun-Lie on 24-11-2009 10:34:12 AMHi Jeff,everything well here - how are you? 🙂In the crestron module I have not specified any speeds for pan, tilt, zoom for the camera controls. This is definately something that could be added to the module.If they want to add it themselves this is what they need to do:Open the "TANDBERG C90 + C60 Serial/Telnet v1.x.umc" file, look at the symbols under "Logic - S-1.1 CameraNear Move" and edit the commands send to "To_Device" to include a xxxxspeed: <1-15> where 1 is slowest and 15 is fastest. e.g.:1xcommand Camera Ramp CameraId: 1 pan:left panspeed:1
2xcommand Camera Ramp CameraId: 1 tilt:up tiltspeed:3
3xcommand Camera Ramp CameraId: 1 zoom:in zoomspeed:5
Testing the commands I don't recommend using zoomspeed below 5 as this gives jerky movements - I'll report this as a bug.David
