This document was generated from CDN thread
Created by: Bret Wittmann on 04-06-2010 02:50:44 AM
HI David,
I noticed that when I store a camera preset from 1 to 15, it moves both cameras [we have two hooked up]. However I used the first 5 presets for camera 1 and the second 5 presets for camera 2. Is there a way to have preset 1-5 only move camera 1 to its preset without moving camera 2 ?
Subject: RE: Camera Presets -- C90
Replied by: Jonas Tysso on 09-06-2010 02:18:04 PM
Hi Bret,
You can use the Crestron Control panel to do this, but I'm afraid this is not possible using camera presets only.
Cheers,
Jonas
Subject: RE: Camera Presets -- C90
Replied by: David Bruun-Lie on 16-06-2010 12:44:30 PM
Bret,
a preset stores (and recalls) the positions for ALL cameras. We are, however, aware that this may not be satisfactory for everyone and being able to recall presets individually per camera is something that we are looking into.
Until then a workaround to achieve the same with a control system is to use the command xCommand Camera PositionSet CameraId: x and hardcode the ptzf values to create your own "presets" within the crestron code.
Regards,
David
