This document was generated from CDN thread Created by: Andy Wander on 02-05-2011 05:54:12 PM I get:Exception receivedjava.util.concurrent.ExecutionException: java.lang.RuntimeException: org.apache.http conn.HttpHostConnectException: Connection to https://10.150.0.47:443 refusedI have no problem connectung using TC console to a C40 that is also on my netwrk.Any ideas?AndySubject: RE: can't log in to C60 using TC console Replied by: Viggo Fredriksen on 03-05-2011 10:45:49 AMHi Andy, are you able to access https://10.150.0.47:443 directly using your web browser? If notyou could try to set the following configurations, reboot the codec and check if TC Console works1xConfiguration NetworkServices HTTP Mode: On
2xConfiguration NetworkServices HTTPS Mode: Off
Subject: RE: can't log in to C60 using TC console Replied by: Andy Wander on 11-05-2011 02:35:33 PMHi Viggo:Thanks for the reply.-the C40 is running TC4.0.1.240265; C60 is running TC4.1.0.247017-I can't connect to the C60 using https, though it is ON in web config pagesI tried changing the HTTP/HTTPS configuration settings on the C60:They were set at:*c xConfiguration NetworkServices HTTP Mode: On*c xConfiguration NetworkServices HTTPS Mode: OnI tried changing to:*c xConfiguration NetworkServices HTTP Mode: Off*c xConfiguration NetworkServices HTTPS Mode: OnAnd rebootingAs well as to:*c xConfiguration NetworkServices HTTP Mode: On*c xConfiguration NetworkServices HTTPS Mode: OffAnd rebootingAnd in both cases, I can’t connect via https, with or without the ":443"I also realized that the unit had no password set, so I set the adminpassword back to the default, and tried again-still no https connection.Finally, I am having inconsistent results using the CLI commands; I have always been able to use abbreviations of the commands as long as they are long enough to be unique-for instance, "xconf networks" instead of "xConfiguration NetworkServices", but they only work "some of the time" on this unit. Don’t know if it is related.AndySubject: RE: can't log in to C60 using TC console Replied by: Maxim Satchouk on 13-06-2011 02:35:50 PMWe had the same problem with C90 and TС 4.0.4, 4.1.0 & 4.1.1 using https, web config pages is ONIf someone did connect , please let me know how it was done.Subject: RE: can't log in to C60 using TC console Replied by: Roger Boe on 14-06-2011 12:09:46 AMHi Maxim,This could be the case of the unit is not able to generate a HTTPS certificate. We have seen this with others. The unit needs a system name to generate the certificate, so the workaround will be to configure the system name: xConfiguration SystemUnit Name: <name>and then reboot the codec.The system will now generate the certificate and you will be able to connect.Best regardsRogerSubject: RE: can't log in to C60 using TC console Replied by: Andy Wander on 30-06-2011 07:23:13 PMIt "got better" after I upgraded the software to the same 4.1.x version it was already running, and let the codec sit for about a week.It still has no "system name" set.
