This document was generated from CDN thread
Created by: Chet Cronin on 20-01-2012 07:13:12 AM
Need some assistance. I have two MXP6000's and both are on the same network with IP's assigned five digits apart. Only difference is MXP's are on different CISCO switches.
Both MXP6000's are on version 9.0.2.
One MXP can dial via IP to an endpoint with no issue.
The other MXP dialing the same IP endpoint gets disconnect error code 6 ????
The MXP that gets the disconnect 6 error successfully calls other sites via IP with no issue???
Any ideas??
VR
Chet