cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
80
Views
0
Helpful
0
Comments
cdnadmin
Community Member
This document was generated from CDN thread

Created by: null on 02-05-2005 03:22:07 PM
Is there any way to dynamically set a config's class at runtime? I need the ability to change the class used to configure an element based on runtime conditions.

Subject: RE: Dynamically setting Dynamic Config
Replied by: Michael Bochynski on 05-05-2005 06:12:37 PM
Hi Paul,

Audium Studio allows you to use Substitutions for the source of a dynamic configuration. The button with curly braces next to the field for the dynamic configuration source gives you the ability to set, for example, Session Data or Element Data as a source for a dynamic event. This will allow you to set a source based on a runtime conditions.

Hope this helps,
Michael
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Quick Links