Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Created by: kapil khanna on 07-06-2011 05:27:03 PM I am working with CUPI 7.1.3.0ES10. Some of the examples list the HTTP response coming back as both JSON and XML. Is there a configuration that needs to be turned on for JSON response or is that supported in later versions?
Subject: RE: New Message from kapil khanna in Cisco Unity Connection Provisioning In Replied by: Matthew Penning on 07-06-2011 05:30:54 PM You can get JSON or XML back by specifying the ¿Accepts¿ header (e.g., ¿application/xml¿ to get xml)
From: Cisco Developer Community Forums [mailto:[email protected]] Sent: Tuesday, June 07, 2011 2:27 PM To: [email protected] Subject: New Message from kapil khanna in Cisco Unity Connection Provisioning Interface (CUPI) - CUPI Questions: JSON or XML
kapil khanna has created a new message in the forum "CUPI Questions":
-------------------------------------------------------------- I am working with CUPI 7.1.3.0ES10. Some of the examples list the HTTP response coming back as both JSON and XML. Is there a configuration that needs to be turned on for JSON response or is that supported in later versions? -- To respond to this post, please click the following link:
Subject: RE: JSON or XML Replied by: kapil khanna on 07-06-2011 05:33:19 PM So if I do not set any Accepts header the default is XML, correct?
Subject: RE: New Message from kapil khanna in Cisco Unity Connection Provisioning In Replied by: Matthew Penning on 07-06-2011 05:35:54 PM Yes that¿s correct ¿ default is XML
~ Matt
From: Cisco Developer Community Forums [mailto:[email protected]] Sent: Tuesday, June 07, 2011 2:33 PM To: [email protected] Subject: New Message from kapil khanna in Cisco Unity Connection Provisioning Interface (CUPI) - CUPI Questions: RE: JSON or XML
kapil khanna has created a new message in the forum "CUPI Questions":
-------------------------------------------------------------- So if I do not set any Accepts header the default is XML, correct? -- To respond to this post, please click the following link:
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: