This document was generated from CDN thread
Created by: Mariusz Mieszkowski on 31-03-2010 10:46:21 AM
Hi, sorry for my bad english
I have big problem with Tandberg (this one - http://www.tandberg.com/video-conferencing-products/tandberg-edge-mxp.jsp), there are two tv's connected to it (one by s-video, second one by DVI-1). And it looks like someone messed up with configuration, and now i cannot see OSD at all. I can only change between Selfview and local PC, and zoom in/out. I've tried to connect third display by the composite, but it doesn't work too (no OSD). Is there some kind of reset that will load default values?
Subject: RE: OSD
Replied by: Greg Salach on 11-05-2010 05:04:37 PM
Are you still having this issue ? Please let me know i might be able to help.
Thank you
Greg
Created by: Mariusz Mieszkowski on 31-03-2010 10:46:21 AM
Hi, sorry for my bad english
I have big problem with Tandberg (this one - http://www.tandberg.com/video-conferencing-products/tandberg-edge-mxp.jsp), there are two tv's connected to it (one by s-video, second one by DVI-1). And it looks like someone messed up with configuration, and now i cannot see OSD at all. I can only change between Selfview and local PC, and zoom in/out. I've tried to connect third display by the composite, but it doesn't work too (no OSD). Is there some kind of reset that will load default values?Subject: RE: OSD
Replied by: Greg Salach on 11-05-2010 05:04:37 PM
Are you still having this issue ? Please let me know i might be able to help.
Thank you
Greg