This document was generated from CDN thread
Created by: Patrick Groothuizen on 31-03-2011 05:42:29 PM
Is it possible to hide the presentation source on the local monitor when sending it to the far end side? Only the far end camera must be shown.
I am working on a project where a HD document camera is used as a presentation source. During a call the far end side (call center) can start the presentation (FECC) to observe a document presented at the customer side.
Subject: RE: presentation image C40 codec
Replied by: Jonas Tysso on 01-04-2011 09:10:53 AM
Hi Patrick
The Cisco C40 does not support custom layout composing such as the one you describe.
This is only possible using the Cisco C60 or C90
Regards,
Jonas
