Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Created by: Sergei Gorbunov on 11-05-2012 10:32:07 PM Hi! I want to drop call before called address receive any signaling. I've tryed call Call.drop() after CallActiveEv (first event in call queue) but not succeed, call drops only after CallCtlConnOfferedEv when called address already received call signaling. Is there any other method to drop call before called address receive any signaling?
Subject: RE: Prevent call creating Replied by: David Staudt on 15-06-2012 06:02:35 PM This won't be possible unless you 'intercept' the call before it is ever offerred to the target address. There are two main mechanism of doing this: JTAPI: create a CTI route point, and configure the UCM dial plan so that all calls intended for the target DN are sent to the CTI RP instead. Your app can then handle the incoming call, decide on what to do with it, and either redirect it to the target DN or perform some alternative treament (drop the call or play a message, e.g.) CURRI: Implement a Routing Rules Interface app attached to a UCM dial plan Route Pattern. This causes UCM to make an HTTP/XML request to your app with the called/calling IDs, and allows your app to respond with a treament - e.g. allow the call to proceed to the target, reject it, play a message, etc. http://developer.cisco.com/web/curri/home
Subject: RE: Prevent call creating Replied by: javavinay88 (simulated) on 19-06-2012 04:27:32 AM Hi,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
