This document was generated from CDN thread
Created by: Enrico Conedera on 24-01-2012 07:50:13 PM
Assuming you have the correct pinout on the adapter. RevoLabs makes one: 07-XLRTO35M4-01 Cable XLR Female to 3.5 Male (4 Conductor) - 3' $30.00
The nominal input level on the C20 is -35dB. This does not properly match the output on the AudioScience mic. You need to put a mixer in between to boost the signal. This can be a simple mic mixer from Shure, for example.
You can try the experimental command, but I am not familiar with it.
