cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
221
Views
0
Helpful
0
Comments
cdnadmin
Community Member
This document was generated from CDN thread

Created by: Shaun McDonnell on 28-04-2010 06:46:10 PM
I have a customer who is using CUCM 7.1.3.  Everytime my application attempts to send a 'startMedia' xml request message, the phone returns me a <CiscoIPPhoneError Number="1" />.
 
This doesn't make any sense to me as the error message it is returning isn't in the new 'Component API' format that I am expecting.  Furthermore, this works on other customer's systems running the same version of CUCM.
 
Also, I know the startMedia XML message is correct as I am able to post the same message to a phone on a different CUCM install and it works fine.
 
Any idea what might be causing this to happen?  Thanks.
 
-Shaun

Subject: RE: startMedia Component API
Replied by: David Staudt on 28-04-2010 08:08:13 PM
Error=1 suggests there is a formatting problem with the request - some phones are more lenient than others in allowing small variances.
 
Can you provide a network packet capture (Wireshark) of the sequence from the phone's PC switch port?  This will show the exact request/response.

Subject: RE: startMedia Component API
Replied by: Shaun McDonnell on 28-04-2010 08:13:05 PM
Actually, now that I look at it further, it seems that the problem is with a 7960 phone.  Do the 7960s even support 'startMedia' messages?  Thanks.
 
-Shaun

Subject: RE: startMedia Component API
Replied by: David Staudt on 28-04-2010 09:22:56 PM
If you are referring to the 'RTPx:' URIs then yes: these are supported by 7940/60 phones.

Subject: RE: startMedia Component API
Replied by: Shaun McDonnell on 29-04-2010 12:16:11 AM
What about the Component APIs of <startMedia /> ?
 
-Shaun

Subject: RE: startMedia Component API
Replied by: David Staudt on 29-04-2010 04:12:53 AM
The <startMedia> request is a member of the 'Application' features added in 8.3(2) firmware for some newer model phones.  According to table 5-1 in the 8.0 IPPS dev guide, the 7940/60 do not support these features.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Quick Links