cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
59
Views
0
Helpful
0
Comments
cdnadmin
Level 11
Level 11
This document was generated from CDN thread

Created by: kent knowles on 12-07-2010 02:09:13 PM
MCU 4200 series ...TMS 12.2

When scheduling a multisite conference through TMS and utilizing the MCU   the H.323 calls connect fine, BUT there is also a "second"  call put out to units via IP?  The conference works fine, but wondering what wold cause TMS to initiate another attemp via IP to the units? I am presuming it is TMS doing this , because I scheduled a conference with just the MCU and there were no attemps to make a second call....


Thanks

Subject: RE: TMS and MCU Issue
Replied by: Steve kapinos on 12-07-2010 08:35:20 PM
kent knowles:
MCU 4200 series ...TMS 12.2

When scheduling a multisite conference through TMS and utilizing the MCU   the H.323 calls connect fine, BUT there is also a "second"  call put out to units via IP?  The conference works fine, but wondering what wold cause TMS to initiate another attemp via IP to the units? I am presuming it is TMS doing this , because I scheduled a conference with just the MCU and there were no attemps to make a second call....


Thanks


Hi Kent,

This is more of a support/TAC type question rather then a developer/integration question as is the focus of this forum.  I'd ask that you pursue this topic with the TAC in your region or sales support team.  This sounds like a scenario where TMS is not able to identify the site that is connected as the site it was attempting to connect so it assumes the first attempt failed and tries again.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Quick Links