cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
152
Views
0
Helpful
0
Comments
cdnadmin
Community Member
This document was generated from CDN thread

Created by: Shwetha Sanjeev on 11-06-2009 11:13:38 AM
Hi All,
 
I need to transfer video with call using call manager. Can i reuse cisco Video advantage in my application or do i need to implement my own video streaming logic ?
 
Thanks,
Bino

Subject: RE: Video in TAPI Application
Replied by: David Staudt on 11-06-2009 03:19:06 PM
TAPI and JTAPI currently do not support RTP events containing video codec info.  Without them, it would not be possible to implement Cisco UCM managed video on a CTI endpoint/app.

Subject: RE: Video in TAPI Application
Replied by: Shwetha Sanjeev on 12-06-2009 04:29:40 AM
Hi david,
Thanks for your reply.
 
Is Cisco Video advantage is a reusable component ? Can i use that for video transfer.
Currently i am receiving RTP events for Audio calls and im streaming audio.
 
So for the videos call,
When i get the START_STREAMING event from the call manager , do i need to use my own logic to stream the video ????
 
Or can i use video advantage ???
 
Thanks

Subject: RE: Video in TAPI Application
Replied by: David Staudt on 12-06-2009 05:09:12 AM
There are at least two places where CTI would need to be enhanced to provide video support:
 
- Registration.  When a CTI port registers, it reports the RTP codecs that it can support.  CTI currently does not accept the video codecs/parameters as options for registration.  As a result, the CTI endpoint cannot advertise to UCM that it supports video.
 
- Media setup.  When the call is setup, RTP events (start streaming) are sent to the CTI application, indicating where/how it should start sending/receiving media.  CTI cannot now handle passing events with video codec/payload parameters to applications.
 
---------------------
 
Phone+VA does register as a video-capable endpoint.  When the phone receives its video RTP streaming signals (one set for voice, one for video) it communicates with VA to handle the video communication via a private protocol, not exposed to developers at this time.

Subject: RE: Video in TAPI Application
Replied by: Shwetha Sanjeev on 15-06-2009 04:35:46 AM
Thanks david for the information,
For the time being i have introduced my own video streaming logic and i registered CTI port with RTP events.
So when a call is established and i got START_AUDIO_TRANSMIT event, i will start the audio stream plus vidoe(with my own streaming)
 
So here i just want to know how i can improve my video transfer performance using some specific tools for video. I am using Call Manager 7.x
 
 
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Quick Links