This document was generated from CDN thread
Created by: Ryan Espedido on 26-03-2011 01:27:15 PM
Hi everyone,
I'm new to TANDBERG codec equipments. Hoping you can help out.
We've tried to setup a 4-way multisite call using C60 as initiator/host of the conference. Participants of the conference are EX90, C40, MOVI, and C60 itself. We have configured the layout of C60 to looked like the attached file "C60 - Host.png":
However, on the Codec C40, the layout looks like the attached file "C40 - Participant.png":
We like to have the layout of C40 to be the same as C60. How can we achieve this? Can we achieve this using Codec C60 as the other participant using its video compositor feature? Or we need an MCU for this?
Looking forward for your help.
Regards,
Ryan
Subject: RE: Video Layout
Replied by: Eivind Fiane Christensen on 28-03-2011 08:29:33 AM
HI,
With the C40 you have to use the default layouts, so you cannot create your own.
As you mention below there are 2 possibilities to create customized layouts as the one you have created:
- Either only use C60 or C90 where you can use the TC console tool to configure as you like
- Or Set-up a call through an MCU that can decide the layout at each of the endpoints.
BR
Eivind
Created by: Ryan Espedido on 26-03-2011 01:27:15 PM
Hi everyone,
I'm new to TANDBERG codec equipments. Hoping you can help out.
We've tried to setup a 4-way multisite call using C60 as initiator/host of the conference. Participants of the conference are EX90, C40, MOVI, and C60 itself. We have configured the layout of C60 to looked like the attached file "C60 - Host.png":
However, on the Codec C40, the layout looks like the attached file "C40 - Participant.png":
We like to have the layout of C40 to be the same as C60. How can we achieve this? Can we achieve this using Codec C60 as the other participant using its video compositor feature? Or we need an MCU for this?
Looking forward for your help.
Regards,
Ryan
Subject: RE: Video Layout
Replied by: Eivind Fiane Christensen on 28-03-2011 08:29:33 AM
HI,
With the C40 you have to use the default layouts, so you cannot create your own.
As you mention below there are 2 possibilities to create customized layouts as the one you have created:
- Either only use C60 or C90 where you can use the TC console tool to configure as you like
- Or Set-up a call through an MCU that can decide the layout at each of the endpoints.
BR
Eivind