To use a Cisco 1760 router as a gateway in a IP Telephony setup, refer to the following high level feature set:
Symmetric High Bit Rate Digital Subscriber Line (G.shdsl) WAN Interface Card (WIC)
Survivable Remote Site Telephony (SRST) version 2
Cisco IOS Telephony Service (ITS)
Call Admission Control (CAC) for Voice over IP (VoIP) call
Differentiated Services (DiffServ) for voice signaling traffic
G.728 Code Support
Test Command Language (TCL) scripting for Interactive Voice Response (IVR)
Real Time Streaming Protocol (RTSP) enhanced IVR
T.37 fax store and forward
Session Initiation Protocol (SIP)
Media Gateway Control Protocol (MGCP) 1.0 features
The modem pass through over VoIP 1760 can support up to six analog lines and up to 30 Digital Signal Level 0 (DS0) channels in one box when using G711. For a higher complexity codec, the DS0 overall number goes down to 15.
Have UCCX 10.6 loaded and finesse works fine on IE 11 and microsoft edge and works with Firefox but when using chrome when you click on team data or que data nothing loads stays stuck on loading report. Is this a version issue with chrome.
Hello,I am using CCME 8.6 on a cisco 2921 router and I have configure everything correct supposedly, but when I type in the url and sign in, I can see the page, but no sub menus and I cannot click on anything. I have attached what the screens look li...
Need to update a 7925G to firmware version 1.4(3) so I can use with Callmanger 11.5. Callmanager has version 184.108.40.206, but the phone has CP7925G-MFG-F.2.LOADS. The 220.127.116.11 release notes has:Upgrade from Releases Prior to 1.4(3)If your Cisco Uni...
Hello, On weekends we have our helpdesk team with only 1 person on duty. During the week we have multiple people on the call cue. We ran into an issue a few weeks ago where that one agent was on a call, another call came into the cue and was wai...