In Cisco Unity, by default, users can record a greeting up to 90 seconds.
The Class of Service greetings setting specifies the maximum length of greetings. To increase the default greeting length for a subscriber, perform these steps:
Open the Cisco Unity System Admin page. Determine the Class of Service of the subscriber.
Go to the Greetings section of Class of Service.
Change the value of the Maximum greeting length, in seconds parameter to the desired length. The maximum value can be set to 999 seconds.
This procedure changes the greeting length for the subscriber using the particular Class of Service. To change this only for a particular subscriber, create a new Class of Service, and use it for that subscriber.
i guys, do any of you know the CLI commands for me to get a file from my CUCM to my FTP server? My TAC engineer is on his off hours. He asked me to run this command: utils network capture eth0 file packets count 1000000 size all That...
Running VCSC x8.8.2I plan to upgrade to 12.5.6 and need to know if I can run the 12.5.6 upgrade file directly or do I have to increment from x8.8.2 and if so what firmware version should I use ??? Also on another note I have an old VCSC r...
Running CMS 2.6.1 Was working fine 5 day ago... Nothing noticeable changed but now when I try to login via the admin interface using any browser I get the reconnecting circle ?? Also I can't dial into any of my co spaces. I have ...
We have a Webex Room Kit Plus, we use 4 screen displays, those screens should wake up when the Room Kit is turned on but it seems to be impossible with the four screens (It works with two screens). It's there a third party accesory or Cisco which we ...
We are trying to configure an embedded CUIC report to display in Finesse, we receive an error when the report attempts to load. View ID:99E6C8E210000141000000D80A0006C4 not found Example of XML data <!-- HTTPS Version of LiveData Gadgets...