The network configuration is interfering with Component Object Model (COM)/Distributed COM (DCOM) operations or the recording(s) that the Media Master control bar does not play are recorded in the G729a format.
Because the Media Master control bar relies on DCOM communication to communicate with the Cisco Unity server, verify that DCOM communication is enabled on the subscriber workstation and on the Cisco Unity server.
Verify that the AvCsMgr and AvCsGateway services are running as a distinguished Cisco Unity account (as specified during installation) and not the Local System account.
Verify that the subscriber has the G.729a codec installed on the workstation, and that the recording(s) are still not playing. If this is the case, refer to Cisco bug ID CSCeb21978 for more information.
Apart from the two solutions discussed above, verify that there is no firewall between the subscriber workstation and the Cisco Unity server. The Media Master control bar does not work through a firewall. Disable virus-scanning services and VPN Client software on the subscriber workstation, as applicable.
Hello Experts,Please find Attached,I have a cisco 2911 with CME and recently bought a sip trunk with a local provider, but i can't get it works.the provider Provided a LAN cable from there MDU Box and they provide a static IP address, subnet mask, an...
Dear all I have 9971 phone and I am trying to perform a factory reset and the phone is not resting also in the setting menu I do not have administrative setting icon there is only call History and running application ...
Hello Community, Need help with below.I have setup as PRI > 4800 > CUCM 11.5 > vg224 > FaxAttached are configs.When I dial fax DIDs 4800 shows call under "sh voice call status" but same call does not go to VG224 and to fax. Please advise....