To change the prefix dialing digit for access to an outside line in Cisco CallManager, go to Route Plan > Route Pattern and change the prefix number from "9" to x (where x is the desired prefix digit), as such:
Route Pattern* - 9.5816XXX
Note: In the event, "9" must be sent along with the number to complete the call, add "9" under Called Party Transformations for Prefix Digits (outgoing calls).
Hello Community, Need help with below.I have setup as PRI > 4800 > CUCM 11.5 > vg224 > FaxAttached are configs.When I dial fax DIDs 4800 shows call under "sh voice call status" but same call does not go to VG224 and to fax. Please advise....
Network  IPv4 Assignment: StaticIP Address, GW & Subnet Mask AssignedDX80 IPv4 Address is what it takes from Wi-Fi DHCPI have tried this at a customer site multiple times even used a mobile hot spot, tried firmware downgrade, CLI Commands for...