cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1009
Views
0
Helpful
1
Replies

APIC-EM QoS configuration in site failed.

Diana Karolina Rojas
Cisco Employee
Cisco Employee

Hello community! Here I am again with a new APIC-EM problem.

 

When I tried to deploy IWAN in a branch I got the error attached below. I tried about 6 times, and in all attempts I got the same message "you can not apply QoS on the interfaces". We tried to delete and load the branch from the APIC-EM, we re-applied the licenses on the branch's router, restarted the router, etc. and the problem persist.

APIC can not apply the "nhrp group prm-1.0Mbps" on the tunnel interface or the "service-policy output prm-dscp # iwan-8-id1 # shape # 1.0" on the physical interface.


The rest of the IWAN configuration was deployed OK, we have the DMVPN, EIGRP, ENCRYPTION, all is working ok but QoS was not applied.

 

I was trying to find someone else with the same problem but I could not find a problem like this in the community.

 

Any help will be appreciated.

PD: We do not have auto qos applied in the device.

 

Best regards!

1 Reply 1

Alexander Stevenson
Cisco Employee
Cisco Employee

 

Hello @Diana Karolina Rojas,

 

I found this: Troubleshooting Cisco APIC QoS Policies. Hope it can help you.