TestSituation:
tftp-http-server <---LAN/WAN--->ROUTER + dhcp management vlan <---trunk--->Etherswitch<---trunk--->switch-2960c<---trunk--->9300series
In situation A:
tftp-http-server <---LAN/WAN--->ROUTER + dhcp management vlan <---trunk--->Etherswitch<---trunk--->9300series
The PNP startup receives the dhcp options and boots. Runs the script.
In the situation: TestSituation -> the discovery of the switch does not happen...
I do not see any dhcp requests arriving on the router.
- I enable pnp start-up vlan on the router and on the etherswitch. This command is not possible on the 2960c switch... probably the issue?
- I would like to avoid VLAN 1
Question : someone else with same issue? And found a solution?
Thank you
Bart
