cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
970
Views
0
Helpful
1
Comments
matikow79
Participant
Participant

Here is a sample VSS configuration for 2x Cat6500 with Supervisor 720.

VSS domain config:

switch virtual domain 10
switch 1
switch 1 priority 110
switch 2 priority 100
exit

Create a Port-Channel "mode on" type between two Supervsor:

interface port-channel 1
description VSL Link

switch virtual link 1

no sh

interface range T5/4 -5
channel-group 1 mode on

no shutdown

Commiting following command will save the configuration on both switches and reboot them.

switch convert mode virtual

After the reboot, we need additionally apply this command:

switch accept mode virtual

Now, lets verify the VSS status:

show switch virtual
show switch virtual link
show switch virtual role

Remember to apply this also:

mac-address-table synchronize

redundancy
mode sso
exit

Hope it helps


Comments
pdula
Cisco Employee
Cisco Employee

Pamiętaj tylko, ze port-channel powinien mieć inny numer na obu switch'ach!

Pozdrawiam,

Piotr

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: