Hi everyone
We have set up the Spine Leaf architecture in a LAB environment. 2x Nexus 9500 and 2x Nexus 9300. The system works very well.
We are stuck at one point: the Nexus switch management. Nexus Switches are managed via the Management Interface. To do this, it is necessary to use a management switch and separate this part (like iLO, etc.).
However, we are not aiming for such a structure. We use a VLAN for management. But unfortunately, this did not happen with Spine switches. Because if the relevant VLAN does not assign any physical interface, there is no UP!
Do you have any solutions for this?
Regards.
