cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1148
Views
5
Helpful
1
Replies

Error: Community vlan cannot be mapped on a secondary trunk port

Hi There

I'm trying to configure PVLAN on this switch: Nexus9000 C9348GC-FXP,

-isolated ports are configured properly

-When I try to configure community port using the following configuration I get an error:

!
feature private-vlan
!
vlan 1,205-206,215-216
!
vlan 205
name primary_VLAN_205
private-vlan primary
private-vlan association 215
vlan 206
name primary_VLAN_206
private-vlan primary
private-vlan association 216
vlan 215
name secondary_VLAN_215_community
private-vlan community

vlan 216
name secondary_VLAN_216_community
private-vlan community
!

interface Ethernet1/1
switchport
switchport mode private-vlan trunk secondary
switchport private-vlan trunk native vlan 2
switchport private-vlan trunk allowed vlan 1-3967
switchport private-vlan association trunk 205 215
switchport private-vlan association trunk 206 216
logging event port link-status
logging event port trunk-status
no shutdown

 

When I enter:

A1(config-if)#   switchport private-vlan association trunk 206 216

ERROR: Eth1/1 : Community vlan cannot be mapped on a secondary trunk port

 

Please advise!

Thanx in advance

 

1 Accepted Solution

Accepted Solutions

f00z
Beginner
Beginner

AFAK, community vlans are not allowed on a private vlan isolated trunk port (private-vlan trunk secondary). I haven't used use PVLAN on nexus but that's how it was on the catalyst stuff and I assume it still applies.  

View solution in original post

1 Reply 1

f00z
Beginner
Beginner

AFAK, community vlans are not allowed on a private vlan isolated trunk port (private-vlan trunk secondary). I haven't used use PVLAN on nexus but that's how it was on the catalyst stuff and I assume it still applies.  

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: