12-28-2021 08:01 AM - edited 12-28-2021 08:02 AM
Hello,
I connected a Cisco SFP GLC-T in a Cisco Nexus 5672UP Ethernet1/2 port. To test it, I connected a computer in that port and, after configuring the speed, it showed me the following in the show interface status command:
--------------------------------------------------------------------------------
Port Name Status Vlan Duplex Speed Type
--------------------------------------------------------------------------------
Eth1/1 -- notconnec trunk full 1000 SFP-1000BAS
Eth1/2 -- unknown e trunk full 1000 SFP-1000BAS
Could someone tell me what's the problem here?
Regards,
Franco
12-28-2021 09:29 AM
Hi @Franco R
Can you share the following outputs:
show module
show interface e1/2 show run int e1/2
show interface brief
show logging log | include net1/2
Note: for confidentiality reasons, make sure you delete the serial numbers from "show module".
Cheers,
Sergiu
01-17-2022 06:24 AM
Hello,
Thank you for your help. I discovered on my own the problem: The interfaces were connected by a port-channel in LACP mode. So, when I connected the PC, that error happened.
When I took the interface out of the port-channel, it worked. The interface must have been waiting for another device which speaks LACP.
Cheers,
Franco
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide