pecify the source interface for informs and traps if the management VRF instance is not being used. This allows security devices such as firewalls to identify the source of the SNMP packet. If the source interface or IP address is not specified the primary IP address on the originating (outbound) interface is selected. The inform feature only applies to SNMP v2c and v3. You can configure the source interface globally for all SNMP hosts or per SNMP host.
n7000(config)# snmp source-interface informs loopback0 n7000(config)# snmp source-interface traps loopback0 Per Server Configuration:
Good afternoon Friends, these days I was accessing the DNAC manager and my surprise is that I did not have access, after a basic analysis I observed that the equipment was operational, but without being able to access it via DNA GUI (browser) I also ident...
Today we are going to talk about how to configure backups in the Cisco ACI APIC Dashboard. As you might know APIC is a UCS based CIMC controller and we can check the configuration backups on the Cisco ACI APIC Dashboard. Remember that the HA solution mus...
Listen: https://smarturl.it/CCRS9E14 Follow us: https://twitter.com/CiscoChampion
Organizations are undergoing digital transformation like never before. Global spending on digital transformation of business practices, products, and organization...