VXLAN with statci replication doesn't transmit arp

TsadikuBahiru78025 · ‎04-13-2022

I was configuring vxlan with static replicaiton and it doesn't transfer arp on the tunnel

TsadikuBahiru78025 · ‎04-13-2022

Here is the topology and the configuration.

VTEP1

-------------------------

vpc domain 101
peer-switch
role priority 100
peer-keepalive destination 192.168.1.1 source 192.168.1.2
delay restore 360
peer-gateway
layer3 peer-router
auto-recovery
ip arp synchronize

interface Vlan1
no ip redirects
no ipv6 redirects

interface Vlan3
no shutdown
no ip redirects
ip address 172.20.2.5/24
no ipv6 redirects
ip router ospf 1 area 0.0.0.0

interface port-channel5
description vpc peer link to DC_CRS
switchport mode trunk
spanning-tree port type network
vpc peer-link

interface port-channel10
description VPC member link
switchport mode trunk
mtu 9216
vpc 10

interface nve1
no shutdown
source-interface loopback0
member vni 50
ingress-replication protocol static
peer-ip 3.3.3.1

interface Ethernet1/1
description CONN To DC_CRS_02_eth1/30
switchport mode trunk
channel-group 5 mode active

interface Ethernet1/2
description CONN To DC_CRS_02_eth1/30
switchport mode trunk
channel-group 5 mode active

interface Ethernet1/3
description CONN To NEW-SFS-02 ETH1/31
switchport mode trunk
mtu 9216
channel-group 10 mode active

interface Ethernet1/4
description CONN To NEW-SFS-02 ETH1/31
switchport mode trunk
mtu 9216
channel-group 10 mode active

interface Ethernet1/5
description CONN To NEW-SFS-02 ETH1/31
switchport mode trunk
mtu 9216
channel-group 10 mode active

interface Ethernet1/6
switchport access vlan 50

VTEP2

--------------------------

vpc domain 103
peer-switch
role priority 100
peer-keepalive destination 192.168.1.1 source 192.168.1.2
delay restore 360
peer-gateway
layer3 peer-router
auto-recovery
ip arp synchronize

interface Vlan1
no ip redirects
no ipv6 redirects

interface Vlan2
no shutdown
ip address 172.21.2.5/24