Data Center

Avant de poser une nouvelle question, vérifiez si elle a déjà été répondue. Filtrez les résultats selon vos critères de recherche.
annuler
Affichage des résultats de 
Rechercher plutôt 
Vouliez-vous dire : 
cancel
Bienvenue à la Communauté Cisco !
La communauté est un hub pour se connecter avec vos pairs et les spécialistes Cisco pour demander de l'aide, partager votre expertise, développer votre réseau et évoluer professionnellement.
Nouveau ici ? Cliquez ici pour en savoir plus et commencer.
Community Live Mai 2025
Community Live Juin 2025
Archives

Parcourir la Community

Discussions de Data Center

Cherchez-vous à approfondir vos connaissances sur Data Center ? Relevez le défi tout en aidant à rép...

44 Messages

Documents de Data Center

Aimez-vous la technologie ? Connectez-vous avec d'autres enthousiastes ! Partagez avec nous des docu...

14 Messages

Blogues de Data Center

La technologie est en constante évolution : Nouveaux concepts, introspection, réflexion... Publiez e...

10 Messages

Vidéos de Data Center

Maintenant, vous pouvez aussi publier vos vidéos ! Utilisez l'icône vidéo pour télécharger le fichie...

4 Messages

Activité dans Data Center

VXLAN EVPN et le process MAC et MAC/IP Learning

  Leaf-1 apprend l'adresse MAC de Host-1 en vérifiant la Source MAC du premier paquet entrant et remplit la table des adresses MAC. Leaf-1 installe l'information sur l'adresse MAC dans la VNI 50140 Layer Routing Information Base (L2RIB) ou la table...

Meddane_0-1737312507876.png Meddane_1-1737312507886.png Meddane_2-1737312507938.png Meddane_3-1737312507952.png
Meddane par VIP
  • 370 Visites
  • 2 réponses
  • 2 Compliment

Block a port ?

Hello,I have a wifi acces point connect to a switch C2960X.Often people unplug cable and connect its equipments in place of this wifi acces point !I was considering to configure port-security on this port, but i'm afraid to block all wifi trafic ... ...

jmb09 par Level 1
  • 824 Visites
  • 10 réponses
  • 0 Compliment

Un overview du VXLAN EVPN pour simplifier le concept

Le VXLAN permet d'étendre un niveau 2 à travers une liaison niveau 3 avec l'encapsulation Mac in UDP, l'idée est d'avoir des machines dans le même sous-réseau (le même vlan) à travers des liaisons entre les leafs et les Spines en Niveau 3. Pour cela,...

Meddane par VIP
  • 589 Visites
  • 0 réponses
  • 2 Compliment

Not enought Power Inline for Access Point

Hello,I have a Cisco 9200 where is connected my Cisco Access Point 3800 Series.The Access point is attached normally to the controller Cisco 5520 but the SSIDs are not shown arroudn the Access Point. I think that it is due to the fact that the switch...

malickmbaye_0-1722627956066.png malickmbaye_1-1722627976697.png malickmbaye_2-1722628048830.png

Résolu! Route-map on Nexus OS

Hello,i have created a route-map and i want to apply it on an interface PortChannel but the command is not working.It seems that there is no ip policy command.Note that i did the same command on another VDC and it works fine.Does i need to activate s...

malickmbaye_0-1720432327474.png

IPN change OSPF external E2 network

By default ACI multipod IPN L3out OSPF external network are E2. I have requirement to change them to type E1. is it possible ? how? I tried to configure  route map default export  to change E2 to E1 but it did not work.

mzouggagh par Level 1
  • 414 Visites
  • 0 réponses
  • 0 Compliment