I have static default route configured in L3out-01
I have multiple OSPF L3outs with 0.0.0.0/0 and both “Export Route Control Subnet” and “Aggregate Export” are enabled
I need to filter default route when exporting route from one of the OSPF L3out.
...
By default ACI multipod IPN L3out OSPF external network are E2. I have requirement to change them to type E1.
is it possible ? how?
I tried to configure route map default export to change E2 to E1 but it did not work.
We have two independent active standby FW-HA in pod 1 and two others FW-HA in pod 2.these FW inspect N-S traffic and E-W traffic. PBR destination in an L3Out was the chosen design option.
We configured one L3out to both FW-HA, but when we configure...
Hi,
we wrote ansible script to create 200 vlan pool in ACI APIC, but execution is too slow. it take more than one hour to finish the job!
With postman it take 2 minutes to create 200 vlan pool.
how can we improve ansible time execution?
after reloading C9300 switch (version 17.6.4), interface te1/1/4 go to down state, and log display:
%SFF8472-3-READ_ERROR: Te1/1/4: Error reading DOM data from transceiver
if I unplug / plug cable in Te1/1/4, interface go back TO UP state. (it is not...
Hi @Remi-Astruc
Thanks, your recommendation is working. we tried an other method: 1) 0.0.0.0/0 with “Export Route Control Subnet” and “Aggregate Export” from L3out EPG 2) created route control profile: - Match routing policy only - deny...
Hi @Remi-Astruc ,
Nice to meet you too.
so from l3out where I want to filter 0.0.0.0/0:1) I delete 0.0.0.0/0 with “Export Route Control Subnet” and “Aggregate Export” from L3out EPG2) create default-export route map with 2 seq, 1 matching 0.0.0.0/1...
Thank you @Torbjørn
adding async 60 and pool 0 to the script reduced time execution to about 4 minutes
the drawback of this method is the result display all tasks in changed state
