Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I got an issue with a VPC link after upgrading my two VPC peers to 10.3.5(M) NXOS, below i little demonstration on how my my connections are: My ports configuration is like this: N9K1#interface ETH1/9lacp rate fastswitchportswitchport mode tr...
Hi guys, I have a confusion about eBgp multi-hop, i always see just the multihop sets to 2, when using loopbacks and we have a router between peers, but what if we have a couple of routers that we can't count what we'll set as mutli-hop, is still 2 h...
Hello everyone,I'm trying to comprehend the distinction between the two types of Route Profile configurations within the L3 configuration of a Bridge Domain. I came across some information, but it's still not entirely clear to me. If anyone could pro...
Hello guys, I'm new on the NX-OS Spine and leaf Fabric IP Architecture, and i would like to understand some terms that i saw in our visio schemas like satellite leaf, centrale spine.
Hello all,I'm new to Cisco SD-ACCESS technology, and i have to migrate two 2 and 2 firewalls to the SDA Fabric on the border switch, the two routers are connected to the traditionnal campus with BGP, but the 2 firewalls have only static routes, i'm w...
@MHM Cisco World thanks for your replay Primary switch: show vpc role vPC Role status----------------------------------------------------vPC role : primaryDual Active Detection Status : 0vPC system-mac : 00:23:04:ee:be:65vPC system-priority : 32667vP...
Hello @MHM Cisco World in fact before ugrading the switch i did a write memory so noting is changed when it comes to configurations, i double checked the things you mentionned above:- Vlan is allowed on the peer link - we don't use MST - in the prima...
Hello @MHM Cisco World , thanks for your reply 1- no when i let the two portchannels up i cannot see then on spanning three2 - also VPC on the two N9K goes down when both portchannels are UP, when i let only one portchannel UP, vpc also terns up
But what i can't understand what is the difference between a leaf and satellite leaf, because both are directly connected to the Spines, i think the use of the satellite leaf is when we don't have more ports on a POD we add satellite leaf for ports e...
