Dynamic Tunnel Sandbox SD-WAN

[Jose Vela]

Hello,

I am testing in the SD-WAN sandbox the dynamic tunnels, but it is not working.

I think it is because the DC does not allow performace TE as a service.

Although if I configure by CLI, it allows it, but I don't know if that's what I'm configuring, has anyone tried this in the SD-WAN sandbox and had the same thing happen?

dc-cedge01#config-t
developer connected from 127.0.0.1 using console on dc-cedge01
dc-cedge01(config)# sdwan
dc-cedge01(config-sdwan)# service te
dc-cedge01(config)# comm
Commit complete.
dc-cedge01(config)# sdwan

[bigevilbeard]

@Jose Vela you mean if you use the UI (vManage) or API this does not work, but as you shown direct configuration on the edge device does work? What is the error message or the result when you said 'not working'?

Never seen this fyi - just curious is this is sandbox issue or a bug in the code train.

[Jose Vela]

Hello,

I leave you some screenshots, I have configured the TE in the site_3 vEdge since in the DC cEdge does not allow it.
In the vManage you can see that all the tunnels are up, there is none INACTIVE. So, I think it is not working, because all the tunnels are up.
Or am I missing something to configure? I have followed this guide:

https://swat-sdwanlab.github.io/mydoc_dt.html

    

 

[bigevilbeard]

Is there traffic between the sites? For configuration help, i would cross post this question here also --> https://community.cisco.com/t5/sd-wan-and-cloud-networking/bd-p/discussions-sd-wan