EVPN and Bridge domain not working in CML

[kaushik_gosar]

Hi,

Has anybody tried to simulate Bridge domain and EVPN in a Cisco Modelling Lab environment

For me, even a simple Bridge domain with BVI was not working

I followed Cisco IOS XR configuration guide but I am not able to ping the BVI interface from the end device.

In case of EVPN, the local MAC address itself is not getting learnt.

Any suggestions ?

Thanks

[balaji.bandi · Accepted solution]

i think that is a limitation with virtual I guess.  (Hope you have CML2 here ?)

[kaushik_gosar]

Hi,

I am using the Cisco Modeling Labs (Sandbox environment). 

When I check in the help section, the version is displayed as V2021 V2.0

Is it confirmed that Bridge domain/EVPN requires actual H/W and CML will not support it ?

Thanks,

[bigevilbeard · Accepted solution]

@kaushik_gosar I dont think any multipoint L2 works on XRv, i think only VPWS on XRv9000 with 6.4.1 and then nothing even with current 7.4.1: https://www.cisco.com/c/en/us/td/docs/routers/virtual-routers/xrv9k-74x/release/notes/b-release-notes-xrv9000-r741.html#concept_15579287A4DGCHJFHDEKJ12234

Hope this helps.